Categories
How

How To Get Rust Off Bike Chain

Are you interested in knowing how to get rust off your bike chain? You will be surprised to know that you don’t actually have to spend money on a professional rust remover. All you need is a small amount of elbow grease, a screwdriver and a small quantity of borax.

The first thing you are going to want to do is to take off the cover on your bike chain. There are a few ways to do this. You can either simply take it apart using the appropriate tools, or you can also do it by hand with the help of a knife. If you choose to do it by hand, I suggest you use some sandpaper and a chisel.

Once you have removed the cover, take a piece of metal and rub it into the rust so you can loosen up the rust. It is important not to get it too close to the joint as you don’t want to melt the chain up. If you do, then you’ll have a very difficult time getting rid of the rust.

After you have done this, you will want to take a bit of dish detergent and wash up the rust. You may want to leave the detergent on for a little while, but then you want to take a rag and scrub down the rust. You don’t want to scrub too hard though. This may damage the metal.

If you are having trouble getting the rust to come out, then you could try applying the same dish detergent and scrubbing method again. In many cases, you will be able to remove it and you won’t have to worry about the metal getting damaged.

After you have done this, you should now take a small amount of borax and put it on the end of a rag. This will act like a rust remover for you. Let this sit on the area for a few hours, and then you can either take the rag off the area and rub it into the rust, or you can rub some more borax on the same area and let that sit for another few hours.

After you have done this, you will want to take a wire brush and start to work on getting the rusty rust off the chain. You will want to start at the ends and work your way in to the center. You’ll have to work in small sections as well as you would if you were trying to remove a larger piece of metal.

Once you’ve taken all the rusted off, you will then want to put some aluminum foil on top of it. You want to do this to protect the chain from any more rust as well as it is not good for it. You can put it over the entire chain to keep it from rusting back.

If you’re dealing with a big area, then you may want to use a rust removal product to do the job. These are available at most hardware stores and you’ll want to make sure you are using the correct one though. There are some very effective ones on the market and you want to make sure you know what you’re using.

You can even make a mixture of the rust remover and water to use. This will help to get all the rust off and keep the chain in good condition. You can also use a solution that has baking soda as well, but be careful to make sure you don’t let it sit too long.

If you have a very small area, then you can try an old toothbrush and some baking soda that you will need to make sure is fresh. It may take a little while but you can be sure that you have success with this method.

It really isn’t that hard to do a rust removal process on your bike chain. Just remember, just use the above tips and make sure you clean it up well afterward.

Leave a Reply

Your email address will not be published. Required fields are marked *