How To Put Bike Chain Back On Derailleur

If you have a derailleur that goes missing, there are some steps that you can take that will help you put it back on your bike and save yourself the time it would take to do it by yourself. This article will explain what you need to do and why it is so important to find a replacement at the first signs of trouble.

To start with, take your derailleur out of the housing on your bike. Make sure that you take the derailleur bar assembly with you when you take it out as this will be an easy task for you to complete. Next, take your chain off of your bike. Remove the old one from the inside of the housing and place it where it meets the derailleur.

This is your rear derailleur that was taken out in the previous step. Take the sprocket off and place it in the derailleur housing where it should be.

The next thing to do is take the back of your derailleur and slide it across the inside of the housing. You should be able to fit it quite easily but you may have to press it in a little bit.

Next, remove the sprocket and slide it down over the sprocket hole on your derailleur. You should be able to do this easily but it may take a little bit of effort. Now that you have the sprocket removed, you can unscrew the nut that holds your chain on the derailleur.

With your nut removed, pull the chain through the slot on the back of the derailleur. You may have to wiggle it around a bit in order to get the chain to run smoothly.

Now that you have the chain free, you can remove the nut and bolt that secures your chain in place. These will be on the other side of the housing.

The last thing that you will need to do is to reinstall the housing on your derailleur. Now that everything is in place, attach your new chain to your derailleur and tighten the nut that holds your new chain on the derailleur housing. This should take about a minute or two. Then, put the housing back on your bike and ride again check for any trouble spots that may be causing difficulty.

That is how to put bike chain back on derailleur housing. It is definitely not as difficult as it might sound but it will be worth the little bit of extra time it takes to do it.

To take out the old derailleur, simply remove the sprocket that has been attached to your derailleur with one of the nuts and bolts that hold it in place. Next, loosen the sprocket that runs out from the other side. Now, slide the nut out. Take the nut and bolt that secures the chain on the derailleur and pull it out.

There are several ways to go about taking out an old derailleur. If you want to take it out without damaging your bike, you can try a wrench this one, but if you are afraid of it happening, you can always call a professional to come out to your house and make sure that everything is fine.

How to put bike chain back on derailleur housing is something that many people learn over the years. If you are serious about fixing your bike or if you just want to upgrade your bike to a new derailleur then I highly recommend that you learn how to do it yourself.

Don’t take chances when installing your new derailleur because it could mean the difference between getting a quality derailleur that will last for a long time and spending a lot of money. By putting together a few simple steps and doing a bit of research online, you can learn how to put bike chain on your derailleur with ease. I think that will be a valuable lesson you will never forget!

Leave a Reply

Your email address will not be published. Required fields are marked *